10 oz Black Tumbler + Lid
$15.00 $10.00
10 oz Stainless Tumbler + Lid
$15.00 $10.00
20 oz Stainless Steel Cup
$20.00 $15.00
5-Piece Lucky $13 Tool Set
$17.50 $13.00
Radio Bracket Combo
$50.00 $40.95
S2000 Stretch-Fit Cap
$22.00 $15.00
Start Button Tee Shirt
$25.00 $15.00

Kenwood PnP Harness (old)

Kenwood PnP Harness (old)
Kenwood PnP Harness (old) Kenwood PnP Harness (old) Kenwood PnP Harness (old)
Vehicle Usage: S2000
Availability: In Stock
Add to Wish List

Easiest installation ever - this custom Plug-n-Play harness connects into the head unit, the car's stereo harness, and our DCI (Dash Control Interface) to simplify installation of a Kenwood head unit and DCI. This harness greatly reduces installation time and there are no worries about making the right wire connections. Check head unit connector compatibility before ordering (see info at bottom of page).

  • DCI (sold separately) is needed to convert S2000 dash control signals into head unit commands.
  • Can be used without a DCI for a "no splice" installation of Kenwood head units (without DCI the dash controls will not work).
  • Amp "turn-on" lead (blue/white) is wired to power the S2000 antenna but may be T-tapped for use with an external amplifier.
  • Only works on DCIs with a 6-pin connector (sold 2012 or later).  If your DCI has an 8-pin connector contact us for help.

If you want to make use of the SCV (Speed Controlled Volume) feature of the DCI you will need to buy the optional SCV wiring kit (SCV Details here).  This kit consists of a pre-terminated wire that plugs into the DCI connector, and then the other end is run behind the passenger dash to T-tap the vehicle speed signal.  No special tools are needed and all parts and connectors are included.  Detailed instructions with photos are included in theSCV wiring Kit.

Connector Compatibility - Beginning in 2017 Kenwood changed the connector on some models, as shown in the photos above.  From experience we know that the following models do NOT work with this (old) PnP harness - KDC-168U, KDC-BT268U, KDC-BT568U, KDC-BT768HD, KDC-X301, KDC-X501, KDC-X701, KMM-BT318U, KMM-BT518HD so if you have one of these you need to use the (new) Kenwood PnP.

These model DO work with the old PnP harness - KMM-108U, KDC-HD262U, KDC-BT368U, KMM-BT515HD, KDC-X500, KDC-BT858U, KDC-X898, KDC-BT958HD, KDC-X998

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating:  Awful           Awesome

Enter the code in the box below: