Kenwood Head Unit KDC-X998
$150.00 $125.00
Pioneer Head Unit DEH-X7800BHS
$125.00 $110.00
Pioneer Head Unit MVH-X360BT
$75.00 $60.00

Spacer Rings for Larger Door Speakers

Spacer Rings for Larger Door Speakers
Vehicle Usage: S2000
Stock: Out of Stock Nov 2023?
Add to Wish List
This product has a maximum quantity of 1

What's a "larger" door speaker?  Usually it's a 6 1/2" or 6 3/4" speaker that is NOT listed as fitting the S2000, but when used with our spacer rings it WILL fit.  Using these spacer rings lets you install larger, higher-quality speakers that have a cut-out or depth requirement that retail stores aren't comfortable recommending for the S2000.  As long as your speakers don't go over 5.7" (145mm) cut-out dimension and no more than 3 1/8" top-mount depth they will fit when used with these spacers.  I checked speaker specs on Crutchfield for all the 6 3/4" speakers listed for less than $1000 and I didn't see any that would not work with these spacer rings.  Moving up to a 6 3/4" driver usually brings a larger cone (Sd) and more cone travel (Xmax), both of which will benefit bass response.

These spacers are CNC-machined in our shop from high-density urethane, which has many benefits over wood-based products.  In addition to a 66% weight savings vs MDF, this material is dimensionally stable, dampens vibrations better, and is impervious to water.  And because it's not as hard as MDF you can mount your speakers without the need to pre-drill pilot holes when using the self-starting deep-thread screws that we supply.  If you need more than 4 screws for each speaker we suggest you purchase an extra pack of 8 screws from us, as not all "wood screws" will hold well in this material.

  • Price includes a PAIR of spacer rings, mounting screws for the spacer rings, plus screws to mount your speakers (4 each speaker)
  • Speaker rings fit most larger 6.5" or 6.75" speakers with a cut-out between 5.4" (137mm) and 5.7" (145mm).
  • 3/4" thickness accomodates speakers up to 3 1/8" deep (top-mount depth)
  • "Pocket" holes on the back side allow for a flush fit between the ring and door panel, normal "flat" speaker rings leave a gap and don't seal well
  • Special cuts on top and bottom edge for door panel clearance
  • Radius cut on inside circle allows drivers with a curved flange edge to fit flush

Do not buy if your speaker cut-out is less than 5.2"; buy the "typical" spacers instead.  This product cannot be returned if it has been installed (has holes or any other alterations). 

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating:  Awful           Awesome

Enter the code in the box below: